Yamaha Warrior 350 Ignition Switch Wiring Diagram

The Yamaha Warrior 350 is a sport quad that was produced from 1987 to 1990. It is powered by a 350cc single-cylinder engine and has a four-speed manual transmission. The ignition switch is located on the left handlebar and is used to start the engine, turn on the lights, and activate the horn. The ignition switch wiring diagram for the Yamaha Warrior 350 is shown below.

2000 Warrior 350 Ignition Switch Wiring Diagram

The following is a description of the ignition switch wiring diagram for the Yamaha Warrior 350: *

1.

Battery positive terminal. *

2.

Ignition switch. *

3.

Starter relay. *

4.

Starter motor. *

5.

Headlight. *

6.

Horn. *

7.

Taillight. *

8.

Brake light switch. *

9.

Neutral light switch. *

10.

Ground. The ignition switch is a simple mechanical switch that is used to connect and disconnect the battery from the rest of the electrical system. When the ignition switch is turned to the "ON" position, it connects the battery to the starter relay, which in turn connects the battery to the starter motor. This allows the starter motor to turn the engine over and start it. The ignition switch also has a "RUN" position, which connects the battery to the headlight, horn, and taillight. This allows these electrical components to operate when the engine is running. The ignition switch also has a "OFF" position, which disconnects the battery from the rest of the electrical system. This prevents the battery from being drained when the engine is not running. The ignition switch wiring diagram for the Yamaha Warrior 350 is a simple and straightforward diagram that shows how the ignition switch is connected to the rest of the electrical system. This diagram can be used to troubleshoot electrical problems with the Yamaha Warrior 350.

1990 Yamaha Warrior Wiring Blue Tra Forum