dolphin gauges installation manual

Installing a Dolphin Gauge in Your Vehicle

Driving a vehicle with a Dolphin Gauge installed offers drivers a variety of benefits. From improved fuel economy to the ability to monitor performance and track the vehicle’s performance, the Dolphin Gauge offers drivers access to an array of options that help them keep their car running at peak efficiency. Installing a Dolphin Gauge is relatively straightforward, but it does require some basic knowledge of automotive mechanics and electrical systems. To make sure everything goes smoothly, check out this installation manual that provides step-by-step instructions on how to install your Dolphin Gauge.

To start off, you must first gather all the necessary materials. This includes the Dolphin Gauge itself, a wiring harness, mounting hardware, and any other parts needed for the particular model of your Dolphin Gauge (the exact components may vary depending on the make and model). Once you have all the components, you can begin the installation process.

First, locate the factory wiring in the engine compartment of your vehicle. Disconnect the factory wiring connector from the engine block or ECU. If your Dolphin Gauge comes with its own wiring harness, plug it into the factory wiring. Otherwise, you will need to connect the existing wires from the factory wiring directly to the Dolphin Gauge.

Next, mount your Dolphin Gauge. The exact procedure for mounting may vary depending on the model of your vehicle, but generally you will need to attach the mounting bracket to a flat surface, such as the firewall or fender of the car, and then attach the Dolphin Gauge to the bracket. Make sure the gauge is level and securely fastened.

Once the gauge is mounted, you will need to connect the wiring harness. Depending on the model of your Dolphin Gauge, this may involve using a plug-and-play setup or soldering the wires onto the gauge. If your Dolphin Gauge comes with a wiring harness, follow the instructions supplied with the harness.

Finally, you will need to run power to the gauge. This can be done by tapping off an existing 12-volt source, such as the vehicle’s battery or an accessory fuse. It is important to connect the positive and negative terminals of the gauge correctly.

Once the power is connected, the Dolphin Gauge is ready to use. You can now set up the various parameters and configurations, such as setting the gauge to read in either digital or analog output, adjusting the display brightness, and setting the threshold for when the gauge should alert you that performance is slipping.

Installing a Dolphin Gauge in your vehicle is a relatively straightforward process, but it does require some basic knowledge of automotive mechanics and electrical systems. By following this installation manual, you can ensure that your Dolphin Gauge is installed correctly and your vehicle is running at peak efficiency.

Tpi Dolphin Gauges Need Help International Full Size Jeep Association